Contact

Get in Touch

Have questions or need help with assembly? Reach out through any of the channels below.

Discord

Connect directly on Discord to chat or get help.

Direct Email

Send an email directly for inquiries or support.

[email protected]

Community

Find 3D prints, makes, and community builds on Printables.

View on Printables

Send a Message

I will get back to you as soon as possible.

Common Questions

Before reaching out, check if your question is already answered here.

Is this free?

Yes, the code and design files are open. You just need to buy the hardware components.

Do I need Arduino software to flash the firmware?

No. I've integrated a flashing tool directly into the Wdeck App. Just plug in your ESP32, open the flash menu, and it's done in seconds. No coding or IDE setup required.

Which OS is supported?

Right now it's for Windows. Mac support is on the roadmap but not ready yet.

Can I contribute to the project?

Absolutely! The firmware and app source are open. Feel free to fork, improve, and submit PRs. Community makes on Printables are also always welcome.

Where do I get the STL case files?

All 3D print files are available on Printables. Updated case designs are published there.

My display shows nothing after wiring — what do I do?

Double-check the GPIO pin mapping in the wiring diagram on the Hardware page. Swap MOSI lines if needed and verify 3.3V is used, not 5V.